Straight seam automatic welding machine is a kind of automatic welding machine. It is a kind of equipment for automatic welding of linear weld. It is mainly used in the production of large cylinder, H-section steel and the welding of some linear equipment. This kind of welding generally has large welding area and long length. If manual welding, the speed is slow and the workload is large. The following is the introduction of some precautions for the use of straight seam automatic welding machine.

直縫焊接機的使用，經常會需要一些配套的設備，才能完成作業，所以要注意的是，不同的產品，需要配備不同的焊接輔助設備。在長度上，超過兩千毫米以上的工件，一般由于設備本身或者工件的誤差，可能會造成焊接縫偏移，因此就需要配置跟蹤系統或者擺動系統來解決這一問題。

The use of straight seam welding machine often requires some supporting equipment to complete the operation. Therefore, it should be noted that different products need to be equipped with different welding auxiliary equipment. In terms of length, workpieces over 2000 mm may cause welding seam offset due to the error of the equipment itself or workpieces. Therefore, it is necessary to configure tracking system or swing system to solve this problem.

在厚度問題上，超過兩毫米以上厚度的鋼板焊接，焊縫的間隙就會比較大，采用工件的母材自身熔化不能填平焊縫，會有一定的焊接缺陷，需要加上自動填絲機構，來填平焊縫，才能完成高質量的焊接。

In terms of thickness, when the steel plate with a thickness of more than 2mm is welded, the weld gap will be relatively large. If the base metal of the workpiece melts itself, it can not fill the weld, and there will be certain welding defects. It is necessary to add an automatic wire filling mechanism to fill the weld, so as to complete high-quality welding.

在設備的使用中，經常會出現一些小問題，但是如果小問題不解決的話，就有可能會造成大問題，所以說，無論是在什么樣的行業，使用什么樣的設備，大家都一定要注意細節，解決掉我們身邊存在的一些小小的問題，可能只需要幾秒鐘，幾分鐘，就能夠避免一些需要幾十分鐘，幾個小時，幾天才能解決的大問題。

In the use of equipment, there are often some small problems, but if the small problems are not solved, they may cause big problems. Therefore, no matter what kind of industry and equipment are used, everyone must pay attention to details and solve some small problems around us. It may only take a few seconds or minutes, We can avoid some big problems that can only be solved in tens of minutes, hours and days.